Connecting Line Level Equipment; (Synthesizer/Computer/Tapedeck/Mixer Line Out) - Native Instruments Komplete Audio 6 Instruction Manual

7.3.4 Connecting Line Level Equipment (Synthesizer/Computer/Tapedeck/
Mixer Line Out)
7.6 KOMPLETE AUDIO 6 setup with a synthesizer and active speakers.
Make sure the KOMPLETE AUDIO 6 is connected to your computer as described during the
installation chapter (chapter 3), and configured as your computer's main audio output device
(see chapter 4). See chapter 7.1 for instructions on how to connect speakers (active and
passive) to your KOMPLETE AUDIO 6.
To use the KOMPLETE AUDIO 6 in a setup with typical line level equipment:
1. Turn the Volume Control knob (MAIN VOLUME 1/2) on the top panel of the KOMPLETE
AUDIO 6 to the left-end stop to set the volume to minimum.
2.
Plug a pair of stereo 1/4" TRS cables from the outputs of your device into the inputs 3
and 4 on the rear panel of the KOMPLETE AUDIO 6.
44 – KOMPLETE AUDIO 6 – Manual