Native Instruments Komplete Audio 6 Instruction Manual page 44

4. Plug the 1/4" TRS jack of your headphone cable into the PHONES socket on the
KOMPLETE AUDIO 6's front panel. Turn the Volume Control knob (VOLUME) in the
headphone section of the KOMPLETE AUDIO 6 to the left-end stop to set the volume
to minimum.
5. Open the audio preferences of your audio recording software, and select KOMPLETE
AUDIO 6 as your input and output device (you may have to restart your host software
for the changes to become active). Refer to the documentation of your audio recording
software for information on how to configure the audio device setup.
6. Make sure that the Volume knob on your instrument is at maximum.
7. While playing your instrument, adjust the input signal by turning the relevant input
channel's GAIN knob gradually to the right. Check the input LEDs (INPUT 1 and 2
LEDs on the top panel of the KOMPLETE AUDIO 6) to make sure your input signal
does not clip; adjust the input level so that the LEDs lights green on input. A red light-
ing LED indicates signal clipping.
8. Gradually turn the Volume Control knob (VOLUME) in the headphone section of the
KOMPLETE AUDIO 6 to the right until you reach a good listening level.
! !
For information on how to adjust the audio input for recording in your audio recording
software, please refer to your software's documentation.
Instead of using headphones, you could also listen to the instrument sound using your
% !
monitor speakers. See the relevant chapters for information on how to connect speakers
to the KOMPLETE AUDIO 6. Always make sure the volume is set to minimum when con-
necting the instrument, and gradually raise the volume afterwards until you reach a good
listening level.
KOMPLETE AUDIO 6 – Manual – 43