Using Komplete Audio 6 In A Setup With Passive Speakers; Connecting Headphones - Native Instruments Komplete Audio 6 Instruction Manual

4. Start the playback of an audio file on your computer.
5. Gradually turn the Volume Control knob (MAIN VOLUME 1/2) on top of the KOMPLETE
AUDIO 6 to the right until you reach a good listening level.
7.1.2 Using KOMPLETE AUDIO 6 in a Setup with Passive Speakers
Make sure the KOMPLETE AUDIO 6 is connected to your computer as described during the
installation chapter (chapter 3), and configured as your computer's main audio output device
(see chapter 4).
Passive speakers require amplification, so there will be a mixer or stereo amplifier between
the speakers and the KOMPLETE AUDIO 6. To use the KOMPLETE AUDIO 6 in a setup with
passive speakers:
1. Turn your stereo amplifier / mixer off.
2. Connect the main outputs (MAIN 1/2) on the rear panel of the KOMPLETE AUDIO 6
to a pair of line inputs on your stereo amplifier / mixer with stereo 1/4" to RCA (phono)
cables or suitable adapters. Connect the L output channel to the left line input chan-
nel, and the R output channel to the right line input channel of your stereo amplifier /
mixer.
3. Turn your stereo amplifier / mixer on.
4. Turn the Volume Control knob (MAIN VOLUME 1/2) on the top panel of the KOMPLETE
AUDIO 6 to the right-end stop to set the output to its maximum level.
5. Start the playback of an audio file on your computer.
6. Gradually raise your stereo amplifier's / mixer's volume control level until you reach a
good listening level.
7.2 Connecting Headphones
7.2 KOMPLETE AUDIO 6 setup with headphones.
Make sure the KOMPLETE AUDIO 6 is connected to your computer as described during the
installation chapter (chapter 3), and configured as your computer's main audio output device
(see chapter 4).
To use headphones with your KOMPLETE AUDIO 6:
36 – KOMPLETE AUDIO 6 – Manual