Native Instruments Komplete Audio 6 Instruction Manual page 39

! !
Make sure the volume on the KOMPLETE AUDIO 6's main outs (Volume Control knob
"MAIN VOLUME 1/2") is turned down before connecting a microphone to the KOM-
PLETE AUDIO 6. Microphones nearby speakers can cause a loud squealing tone from the
speakers due to a phenomenon called the Larsen effect or audio feedback loop and can
seriously damage your hearing and your equipment. The greater the distance between a
microphone and speakers means this effect is less likely to occur.
To use the KOMPLETE AUDIO 6 in a recording setup with a condenser microphone:
1. Turn the Volume Control knob (MAIN VOLUME 1/2) on the top panel of the KOMPLETE
AUDIO 6 to the left-end stop to set the main output volume to minimum.
2. Plug an XLR cable jack from your condenser microphone into either INPUT 1 or INPUT
2 on the front panel of your KOMPLETE AUDIO 6.
3. Switch the phantom power (48V button on the device's rear panel) on. The 48V LED
on the device's top panel will light orange.
38 – KOMPLETE AUDIO 6 – Manual