Hub Assembly Installation; Installing Spool-Type Wire And Adjusting Hub Tension - Miller Electric A.B.B. Robot Interface Gas Control Hub And Spindle Owner's Manual

2-12. Hub Assembly Installation

Tools Needed:
9/16 in

2-13. Installing Spool-Type Wire And Adjusting Hub Tension

Tools Needed:
9/16 in
OM-884 Page 16
2
3
4
1
1
1 Spool Support
2 Hub Support Shaft
3 Retaining Ring
4 Hub Assembly
5 Brake Washer
6 Fiber Washer
7 Hex Nut
Install hub assembly as shown.
Tighten hex nut until a slight drag is
felt while turning hub.
5
6
7
1 Retaining Ring
2 Wire Spool
3 Hole In Spool
4 Hub
Remove retaining ring and slide
2
spool onto hub. Turn spool until hub
pin fits hole in spool. Reinstall re-
taining ring.
3
5 Tension Adjustment Nut
Grasp spool in one hand and turn
while using a wrench to adjust hex
4
nut. When a slight force is needed
to turn spool, tension is set.
5
ST-126 870-A
ST-161 001