Shielding Gas Connection To Regulator/Flowmeter; Shielding Gas Connections To Gas Control - Miller Electric A.B.B. Robot Interface Gas Control Hub And Spindle Owner's Manual

2-5. Shielding Gas Connection To Regulator/Flowmeter

6
5
Tools Needed:
1-1/8, 5/8 in
Obtain gas cylinder and chain to running
gear, wall, or other stationary support so
cylinder cannot fall and break off valve.
1 Cap
2 Cylinder Valve
Remove cap, stand to side of valve, and
open valve slightly. Gas flow blows dust
and dirt from valve. Close valve.
3 Cylinder
4 Regulator/Flowmeter

2-6. Shielding Gas Connections To Gas Control

Tools Needed:
5/8 in
OR
4
Install so face is vertical.
5 Gas Hose Connection
Fitting has 5/8-18 right-hand threads. Ob-
tain and install gas hose.
6 Flow Adjust
Typical flow rate is 20 cfh (cubic feet per
hour). Check
recommended flow rate.
1
2
From Regulator/
Flowmeter
1
2
3
Argon Gas
7 8
CO Gas
2
wire manufacturer's
To Gun
1
2
3
ssb3.1 5/94 – ST-158 697-A
Make sure flow adjust is closed when
opening cylinder to avoid damage to the
flowmeter.
7 CO Adapter
2
8 O-Ring
Install adapter with O-ring between
regulator/flowmeter and CO cylinder.
2
Obtain gas cylinder and chain to running
gear, wall, or other stationary support so
cylinder cannot fall and break off valve.
1 Gas Control
2 Shielding Gas Valve Fitting
ST-080 485-A
OM-884 Page 11