Subscribe to Our Youtube Channel
Related Manuals for TeleEye RM134
Summary of Contents for TeleEye RM134
- Page 1 TeleEye RM134 Before using the product, please read this Quick Start carefully.
- Page 2 1.1 PACKAGE CONTENTS ---------------------------------------------------------------------------------------------------------- 1.2 FRONT PANEL --------------------------------------------------------------------------------------------------------------------- 1.3 REAR PANEL ----------------------------- ----------------------------------------------------------------------------------------- 2.1 GETTING STARTED ------------------------------------------------------------------------------------------------------------- 2.2 SYSTEM TIME SETUP ---------------------------------------------------------------------------------------------------------- 3.1 RECORDING ----------------------------------------------------------------------------------------------------------------------- 3.2 PLAYBACK ------------------------------------------------------------------------------------------------------------------------- INSTALL HDD --------------------------------------------------------------------------------------------- PIN CONFIGURATION ---------------------------------------------------------------------------------- Digital Video Recorder Adapter Licensed Software AP External I/O Port Pin Connector Screws * 4 Power and Data Bus...
- Page 3 • “LED LIGHT” : HDD: HDD is reading or recording HDD Full: HDD is full. ALARM: Once the alarm is triggered TIMER: When timer recording is turned on PLAY: Under playing status REC: Under recording status “MENU” : Press “MENU” button to enter the main menu. “ENTER”...
- Page 4 • “CH1 ” “CH2 ” “CH3 ” “CH4 ” : Press “1 ” “2 ” “3 ” “4 ” buttons to select the channel to display. “REC” : Press “REC” button to activate the manual recording. “ “ Press this button to playback the recorded data. “...
- Page 5 MONITOR CALL LOOP INPUT LOOP INPUT LOOP INPUT LOOP INPUT LINK ACT. EXTERNAL I/O DC 19V • / HI-IMPEDANCE: When using Loop function, please switch to HI-IMPEDANCE. When you don’t use Loop function, please switch to 75 H. • VIDEO INPUT (CHANNEL 1 - 4): Connect to video sources, such as cameras. LOOP (CHANNEL 1 - 4): Video output.
- Page 6 Connect all the devices to construct a surveillance system. Install HDD: The HDD must be installed before the DVR is turned on. Please refer to Appendix #1 for HDD installation instructions. Connect cameras, monitors and external devices. Please refer to the section “1.5 REAR PANEL”...
- Page 7 The DVR offers three recording modes, manual record, event record and timer record. If power is off accidentally, recorded video files will still be stored in the HDD. DVR will return to the original recording status after power is on again. MANUAL RECORDING (continuous recording) : Recording is initiated by manually pressing the “REC”...
- Page 8 Carefully follow the steps to ensure correct installation. *** Note: Please set the HDD to “Master Mode” or “Single Mode” *** • Open the upper cover of the DVR: Loosen the two screws respectively on the two sides of the upper cover. Loosen the four screws on the back side of the upper cover.
- Page 9 Carefully follow the steps to ensure correct installation. *** Note: Please set the HDD to “Master Mode” or “Single Mode” *** Fig. 3 Fig. 1 Fig. 4 Fig. 5 Fig. 2 • Open the upper cover of the DVR and screw out the bracket. •...
Need help?
Do you have a question about the RM134 and is the answer not in the manual?
Questions and answers