PERSONAL SAFETY These precautions are intended for the personal safety of the user and others working with the user. Please take time to read and understand them. AIR-POWERED DUAL-ACTION SANDER 058-9325-8...
Risk of bursting: Do not adjust the pressure switch or safety valve for any reason. They have been preset at the factory for this compressor’s maximum pressure. Tampering with the pressure switch or the safety valve may cause personal injury or property damage. AIR-POWERED DUAL-ACTION SANDER 058-9325-8...
Page 6
Drain water from tank after each use. Do not weld or repair tank. Relieve all pressure in the hose before removing or attaching accessories. MC-OM-22 AIR-POWERED DUAL-ACTION SANDER 058-9325-8...
Page 7
Do not operate the compressor if it is not in a stable position. • Do not operate the compressor on a rooftop or in an elevated position that could allow the unit to fall or be tipped over. AIR-POWERED DUAL-ACTION SANDER 058-9325-8...
Page 8
Do not store the tool in a freezing environment to prevent frost or ice formation on the operating valves and mechanisms of the tool that may cause tool failure. • Do not use the tool for a task that it is not designed to perform. AIR-POWERED DUAL-ACTION SANDER 058-9325-8...
2.8 SCFM @ 90 PSI to ensure the compressor can run continuously with the Mastercraft Air-powered Dual-action Sander. Using tools or a combination of tools that together or separately require more than the air compressor can deliver will reduce performance and could void the compressor or tool guarantee/warranty.
Page 13
Do not use this tool in the presence of any flammable liquids or gases. • Keep hose away from heat, oil, and sharp edges. Check hose for wear and tear, and ensure that all connections are secure. Failure to comply could lead to serious injury or loss of life. AIR-POWERED DUAL-ACTION SANDER 058-9325-8...
Page 18
Potential hazard that may result in moderate injury or damage to equipment. • The tool should be stored in a clean and dry environment. Failure to comply may result in moderate injury or damage to equipment. AIR-POWERED DUAL-ACTION SANDER 058-9325-8...
Air flows instructions. 3. Air flow is blocked by dirt. slightly from exhaust. 3. Operate the tool by reversing rotation of the tool back and forth in short duration. Repeat the above steps as needed. AIR-POWERED DUAL-ACTION SANDER 058-9325-8...
Page 20
If the problem persists, call 1-800-689-9928. Replace O-rings. Tool does not shut Throttle valve O-rings are dislodged off. from seat inlet valve. If the problem persists, call 1-800-689-9928. Note: For further repair information, please call 1-800-689-9928. AIR-POWERED DUAL-ACTION SANDER 058-9325-8...
Page 22
Bearing 6000Z Tee coupling Back cylinder cover Air outlet plug Rotor End cap Rotor blade Dust cover Pin 3 X 14 If any parts are missing or damaged, or if you have any questions, please call 1-800-689-9928. AIR-POWERED DUAL-ACTION SANDER 058-9325-8...
This warranty will not apply where damage is caused by repairs made or attempted by others (i.e., persons not authorized by the manufacturer). This warranty will not apply to any product that was sold to the original purchaser as a reconditioned or refurbished product (unless otherwise specified in writing). AIR-POWERED DUAL-ACTION SANDER 058-9325-8...
This warranty gives you specific legal rights, and you may have other rights, which may vary from province to province. The provisions contained in this warranty are not intended to limit, modify, take away from, disclaim, or exclude any statutory warranties set forth in any applicable provincial or federal legislation. AIR-POWERED DUAL-ACTION SANDER 058-9325-8...
Need help?
Do you have a question about the 058-9325-8 and is the answer not in the manual?
Questions and answers