DSC Power632 PC1555 Instruction Manual page 12

Continued from page 7 ...
Programming codes from an LCD Keypad:
Master Code
Press the [*] key to enter the function list. Scroll (< >) to...
F're__ i'+:i 1 r- Press [5] or [*]. The display will read...
Rc _= t:odes
Er't"' M.y_ t"` Enter your current Master Code. The display will read...
H^^_e__ Code
; to E,Ait. °40P" represents the Master Code. Press the [*] key to indicate that you wish to
U_.er Code 40F
program the Master Code. The display will read...
Ent.er Code Enter the new Master Code. The Master Code must be four digits long, unless
i`i4
otherwise indicated by your installer. Enter digits 0 through 9 only. Once the new
code is entered, the keypad will beep 3 times and the display will read...
to Edit :.>
u_e,- Code a,_,F Press [#] to exit the code programming function.
Be sure to record your new Master Code on the "System Information" page in this booklet.
NOTE: We recommend that the factory default Master Code [1234] not be used.
Additional Access Codes
To erase, add or change a user code, press [*] to enter the function list. Use the arrow (< >) keys to
scroll to the following message...
F're__ (:+:)
r„r- Press [*]. Display will read...
Rc--== f:odes
Er,t.er- riaster Enter the Master Code. Display will read...
Fi[.- = Code
1:+:1 t" Edit Use the scroll keys (< >) to find the access code - indicated by "02P" to "32P" -
U-"'- Code `-'ip you wish to add, change or delete. Press the [*] key to select the code you wish to
change. The display will read...
Enter New Code To add or change a code, enter the new code. Access codes must be four digits
1234 unless otherwise indicated by your installer. Enter digits 0 through 9 only. To delete
an access code, enter [*]. Once the 4-digit code or [*] has been entered, the
keypad sounder will beep 3 times and the display will read...
[:+:1 t.,, E,Ji t. The "P" means the code has been programmed. If there is no "P" then that code is
user- Code GaiF' deleted. Press [#] to exit the code programming function. The Master code cannot be
erased.
Remember to record your new code(s) on the "System Information" page in this booklet.
Access Code Attributes
Additional programmable attributes, such as zone bypassing capability, can be activated or deactivated
for each access code. For more information regarding access code attributes, please contact your
installer.
10