DSC Power632 PC1555 Instruction Manual page 18

FCC COMPLIANCE STATEMENT
CAUTION: Changes or modifications not expressly approved by Digital
disconnection of the terminal equipment. Standard jacks shall be so
Security Controls Ltd. could void your authority to use this equipment.
arranged that, if the plug connected thereto is withdrawn, no interference
This equipment has been tested and found to comply with the limits for a to the operation of the equipment at the customer's premises which
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are remains connected to the telephone network shall occur by reason of
designed to provide reasonable protection against harmful interference in a such withdrawal.
residential installation. This equipment generates, uses and can radiate radio
INCIDENCE OF HARM Should terminal equipment or protective circuitry
frequency energy and, if not installed and used in accordance with the cause harm to the telephone network, the telephone company shall, where
instructions, may cause harmful interference to radio communications. practicable,notifythecustomerthattemporarydisconnectionofservicemay
However, there is no guarantee that interference will not occur in a particular be required; however, where prior notice is not practicable, the telephone
installation. If this equipment does cause harmful interference to radio or company may temporarily discontinue service if such action is deemed
television reception, which can be determined by turning the equipment off reasonable in the circumstances. In the case of such temporary
and on, the user is encouraged to try to correct the interference by one or discontinuance, the telephone company shall promptly notify the customer
more of the following measures: and will be given the opportunity to correct the situation.
Re-orient the receiving antenna.
ADDITIONAL TELEPHONE COMPANYINFORMA TIONThe securitycontrol
Increase the separation between the equipment and receiver. panel must be properly connected to the telephone line with a USOC RJ-31X
Connect the equipment into an outlet on a circuit different from that to telephone jack.
which the receiver is connected. The FCC prohibits customer-provided terminal equipment be connected to
Consult the dealer or an experienced radio/television technician for help. party lines or to be used in conjunction with coin telephone service.
The user may find the following booklet prepared by the FCC useful: "How to Interconnect rules may vary from state to state.
Identify and Resolve Radio/Television Interference Problems". This booklet
CHANGESINTELEPHONECOMPANYEQUIPMENTORFACILITIESThe
is available from the U.S. Government Printing Office, Washington D.C. telephone company may make changes in its communications facilities,
20402, Stock # 004-000-00345-4. equipment, operations or procedures, where such actions are reasonably
IMPORTANT INFORMATION
required and proper in its business. Should any such changes render the
This equipment complies with Part 68 of the FCC Rules. On the side of
customer's terminal equipment incompatible with the telephone company
this equipment is a label that contains, among other information, the facilitiesthecustomershallbegivenadequatenoticetotheeffectmodifications
FCC registration number of this equipment.
to maintain uninterrupted service,
NOTIFICATION TO TELEPHONE COMPANY The customer shall notify
RINGER EQUIVALENCE NUMBER (REN) The REN is useful to determine
thetefephonecompanyoftheparticufarlinetowhichtheconnectionwill
thequantityofdevicesthatyoumayconnecttoyourtelephonelineandstill
be made, and provide the FCC registration number and the ringer
have all of those devices ring when your telephone number is called. In most,
equivalence of the protective circuit.
but not all areas, the sum of the RENs of all devices connected to one line
FCC Registration Number: F53CAN-32028-AL-E should not exceed five (5.0). To be certain of the number of devices that you
Facility Interface Code: 02LS2 may connect to your line, you may want to contact your local telephone
company.
Ringer Equivalence Number: 0113
EQUIPMENT MAINTENANCE FACILITY If you experience trouble with this
Service Order Code: 9.OF telephone equipment, please contact the facility indicated below for
USOC Jack: RJ-31 X information on obtaining service or repairs. The telephone company may ask
TELEPHONE CONNECTION REQUIREMENTS Except for the telephone that you disconnect this equipment from the network until the problem has
company provided ringers, all connections to the telephone network shall be been corrected or until you are sure that the equipment is not malfunctioning.
made through standard plugs and telephone company provided jacks, Digital Security Controls Ltd. 160 Washburn St., Lockport, NY 14094
or equivalent, in such a manner as to allow for easy, immediate
NOTICE: The Industry Canada label identiYes certified equipment. This AVIS: L'Btiquette de I'Industrie Canada identifie le maleriel homologuE. Cette
certification means that the equipment meets certain telecommunications etiquette certifie que le materiel est conPorme a certaines normes de
network protective, operational and safety requirements. Industry Canada does protection, d'exploitation et de securite des reseaux de telecommunicalions.
not guarantee the equipment will operate to the user's satisfaction. Industrie Canada n'assure toutefois pas que le materiel fonctionnera a la
Bcforc inslalling this equipment. users should ensure thal it is permissible to he
satisfaction de 1'utilisateur.
connected to the facilities of the local teleconimunicalions company. The Avant d'installer ce maldricl. I'utilisatcur doit s'assurer qu'il cst perinis de le raccorder
aux
must also be inslalled using an acceptable method of connection. The x installations de 1'entrepr^se locale de tcl6communieation. Le matcricl doit
Egalemenl @lre inslallE en suivant une melhode acceptec de raceordement. L'ahonnc ne
customer should he aware lhat compliance with Ihe above condilions may nol doil pas oublicr qu'il est possible quc la conformitc aux eondilions cnoncce,c ci-dessus
prevent degradalion of service in some situalions. n'empFchent pas la d@gradation du service dans cenaines situations.
Repairs to certified equipment should he niade by an authorized Canadian Les reparations de malcricl homologuE doivent etre effcctuces par un centre
mainlenance facility designated by the supplier. Any repairs or alterations made by d'entrclicn canadien aulorisF dcsignc par Ie fournisseur. La compagnic de
the user lo this equiprncnl. or equipnient nialfunclions, may give the tElecommunications peul demander a I'utilisatcur de d6brancher un apparcil a la
telecotnmunicalions company cause to request the uscr to disconnect the equipment. suite de reparations ou de modifications effectu@es par I'utilisatcur ou a cause dc
mauvais fonclionnement.
User should ensure for lheir own proteclion that the electrical ground connections of Pour sa propre protection, I'ulilisateur doit s'assurer que tous les filc de mise a la terrc
the power utility. tclephone lines and inlernal metallic water pipe spstem. if present, dc la source d'energie rtlectrique, Ics lignes t6I6phoniques el Ies canalisations d'cau
are eonnecled together. This precaution may be particularl}imponanl in rural arcas. ,nc'talliques, s'il y en a. sonl raeeordes ensemble. Cette precaution esi particulieremenl
CAUTION: Users shotdd not allenipl to make such connections Ihetnsclves, hul should importante dans les regions rurales.
contact the appropriale electric inspection authority, or electrician, as appropriale. AVERTISSEMENT: L'utilisateur ne doit pas tenter de faire ces raccordernents lui-
The Load Number (LN) assigned lo each terminal device denotes the percentage of mcme: il doit avoir reeours n un service d'inspection des installations clectriques, ou a
the total load to he connected to a telephone loop which is used by the device. to un cleelricien, selon le cas.
prevent overloading. The termination on a loop ntay consist of any combination of L'indice de charge (IC) assigne a ehaque disposilif terniinal indique, pour Eviter toule
devices subject only to the requirement that the total of the Load Numbers of all the surcharge, lc pourcentage dc la chargc totale qui peul "elre raccordcc a un circuit
deriees does not exceed 100. t@lephonique boucl@ utilisE par ee dispositif. La terminaison du circuit bouelE peut etre
constituce do n'imporle quelle combinaison de dispositif s, pourvu quc la sonime des
The Load Number of lhis nnit is 0.1 B. indices dc charge de 1'ensemble dcs dispositifs ne dEpasse pas 100.
L'Indice de charge de ce produit esl 0.IB.
16