3 Refer to
9.2.3 Reconnecting the Power
MP-7201 AC-DC Power Module
1 Connect the female end of the power cord to the power socket of the power module.
Figure 37 Connecting the Power to the MP-7201 Power Module
2 Connect the other end of the cord to a power outlet.
3 Dress the power cords after you connect them.
Figure 38 Dressing the Power to the MP-7201 Power Cord
4 Turn on the power source (if it is not already turned on).
5 Move the power switches on both power modules to the ON position.
MP-7203 DC-DC Power Module
1 Use a screwdriver to loosen the screw on the cover of the terminal block and remove it.
2 Expose the screws on the side of the terminal blocks.
3 Connect one power wire to the RTN (return) terminal on the MS-7206 power module,
and tighten the screw.
4 Connect the other end of the power wire to the positive terminal on the power supply.
MS-7206 Hardware Installation Guide
Section 9.2.3 on page 75
to reconnect the power after you finish.
Chapter 9 Maintenance
75