Table of Contents
Advertisement
5. Your kettle will reach boiling point and switch OFF automatically. To re-boil,
simply wait a few seconds then re-set the ON/OFF button.
NOTE: Never overfill kettle with water, as this may prevent the kettle from switching OFF
and cause water to overflow from the spout.
6. To switch the kettle OFF manually, simply press the control switch at the top of
handle. Part. 2
GENERAL
Remove the kettle from the power base before pouring.
To avoid the risk of splashing, poor slowly and don‟t over-tilt the kettle
Don‟t tilt the kettle backwards; water might get onto the control area. If this
happens, let the kettle dry before use – sit it somewhere warm for 12 hours.
When you lift the kettle, you may see moisture on the power base. Don‟t worry –
it‟s the steam used to switch the kettle OFF automatically, which then condenses
and escapes via the vents under the kettle. You may see some discolouration at
the base of the kettle. Again, don‟t worry – this is due to the bounding of the
element to the bottom of the kettle.
INSUFFICIENT WATER – BOIL DRY PROTECTION
Insufficient water will shorten the life span of the element. A safety boildry/cut-out
device will switch the kettle OFF automatically.
Should the kettle be accidentally switched ON without any water, or without
sufficient water to cover the element, or be allowed to boil dry, the cut-out device
should be activated.
6
Advertisement
Table of Contents
