Using Your Kettle - Russell Hobbs 10585 Instructions And Warranty

OPERATING INSTRUCTIONS

USING YOUR KETTLE

Before first use please follow these instructions:
Remove the kettle and all the accessories from the carton. It is recommended to keep
the box and protective packaging until some time has passed and you are satisfied that
the kettle is in good working order.
REMEMBER: NOT TO LEAVE PROTECTIVE PACKAGING LYING AROUND, AS IT
COULD BE DANGEROUS AROUND INFANTS.
 Place the kettle on a dry, smooth level surface, and adjust the cord to the desired
length.
 Fill the kettle to the „MAX‟ level and boil. Discard the water and repeat this twice.
POSITION
Place the power base on a stable, level surface. Arrange the power supply cable so it
doesn‟t overhang and cannot be caught or tripped over.
FILLING
NOTE: Keep clear of waterspout during boiling, as steam will escape from the lid.
1. Fill it through the spout or lid. To open the lid, simply press the trigger release,
part 6, on the top of the handle.
a) The water must be between „MAX‟ and 400ml (2cups)
b) Be economical; do not boil more water than is needed.
c) To improve the quality of your drinks always use fresh water.
NOTE: Using purified or mineral water will extend the life of your
2. Ensure the lid is closed properly otherwise the kettle might not switch OFF when
it boils.
3. Plug the power base into the wall socket and if necessary switch the socket ON.
4. With the kettle positioned properly on the base, switch kettle ON by pressing the
knob at the top of the handle part. 2
5