Table of Contents
Advertisement
ELECTRICAL FEEDER CABLE CONNECTION
WARNING: If the power supply cable is damaged, it must be replaced only by an
authorised service agent in order to avoid a hazard.
To connect the supply cable:
•
Unhook the terminal board cover by inserting a screwdriver into the two hooks "A"
(figure 7.2).
•
Open the cable gland by unscrewing screw "F" (fig. 7.3), unscrew the terminal screws
and remove the cable.
•
The new supply cable, of suitable type and section, is connected to the terminal board
following the diagram of fig. 7.4.
NOTE: The earth conductor must be left about 3 cm longer than the others.
POWER SUPPLY
230 V~ 50 Hz
FEEDER CABLE SPECIFICATIONS
Type "H05RR-F"
3 x 1,5 mm
2
28
2350 W
A
Fig. 7.2
230 V
L
N
E
E
Earth
N
Neutral
L
Live
Fig. 7.4
F
Fig. 7.3
Hide quick links:
Advertisement
Table of Contents
