Cleaning & Maintenance - Kenwood KS 100 Instructions For Use Manual

5 - CLEANING AND MAINTENANCE
GENERAL ADVICE
• Before you begin cleaning, you
must ensure that the appliance is
switched off at the oven switch.
• It is advisable to clean when the
appliance is cold and especially when
cleaning the enamelled parts.
• Avoid leaving
substances (lemon juice, vinegar, etc.)
on the surfaces.
• Avoid using cleaning products with
a chlorine or acidic base.
• Important: The use of suitable
protective
recommended when handling or
cleaning this appliance.
• Under no circumstances should
any external covers be removed for
servicing or maintenance except by
suitable qualified personnel.
WARNING:
When correctly installed, your product
meets all safety requirements laid down
for this type of product category.
However special care should be taken
around the rear or the underneath of
the appliance as these areas are not
designed or intended to be touched and
may contain sharp or rough edges, that
may cause injury.
Attention!
The appliance gets very hot, mainly around the cooking areas. It is very important
that children are not left alone in the kitchen when you are cooking.
Do not store flammable material in the oven.
Do not use a steam cleaner because the moisture can get into the appliance thus
make it unsafe.
Do not use harsh abrasive cleaners or sharp metal scrapers to clean the oven door
glass since they can scratch the surface, which may result in shattering of the
glass.
alkaline or acidic
clothing/gloves
Enamelled parts:
All the enamelled parts must be cleaned
with a sponge and soapy water or other
non-abrasive products.
Dry preferably with a microfibre or soft
cloth.
Acidic substances like lemon juice, tomato
sauce, vinegar etc. can damage the enamel
if left too long.
Control panel facia:
Clean very carefully with water and neutral
soap; the cloth used must be rinsed well
is
and must be free of any cleaning chemicals
to avoid damaging any screen print on the
facia.
Do not use harsh abrasive cleaners or
sharp metal scrapers to clean the control
panel since they can scratch the surface,
which may result in shattering of the glass
Door, glass & painted surfaces:
Clean very carefully with water and neutral
soap; the cloth used must be rinsed well
and must be free of any cleaning chemicals.
17