Pairing With A Receiver - AND UC-352BLE Instruction Manual

Pairing with a Receiver

This scale needs to be registered with a receiver in order to use Bluetooth®
communication with the receiver. The process of registering this scale with a
receiver is known as pairing. When pairing is completed, measurement data from
this scale is automatically sent to the paired device each time a measurement is
made when the receiver is in the state in which it can receive transmissions.
Consult the receiver instruction manual and set it to enable pairing. If the receiver
has a "pairing wizard", use the wizard to complete pairing. Place the receiver and
this scale as close as possible to carry out pairing.
1. Install four AAA size alkaline batteries into this scale.
For details, see "Installing (or Replacing) the Batteries".
2. Confirm that the scale is turned off, and press and hold
the Set switch.
When the Set switch is continuously pressed, "pr" is
displayed.
3. Release the Set switch when "pr" is displayed.
The Bluetooth® communication symbol
flashes.
This scale is discoverable by the receiver.
To cancel pairing, press the Set switch when "pr"
is displayed.
4. Start pairing on the receiver.
Follow the pairing instructions for the receiver to
search for, select and pair with this scale.
5. Confirm that "end" is displayed.
Once the scale is paired with the receiver, there is no need
to perform pairing after replacing batteries.
Turn the power of other Bluetooth® devices off when performing pairing.
If measurement data cannot be received, try pairing again.
After pairing is complete, all communications are done automatically if the receiver is
in the receivable state.
In the unlikely event that this scale causes radio wave interference to another wireless
station, either change the location where the scale is used, or stop using the scale
immediately.
Cautions for pairing
English 7
Beep
Beep beep