Installation Instructions - Intelligent Weighing Technology intell-lab ph series User's Operation Manual

 Remove balance and accessories from the carton.
 Do not install the balance in a place with draughts, heavy thermic changes and
vibrations.
 Place the weighing pan and the support pan on the balance (see page 4-5).
 Level the balance using the level bubble and levelling feet located underneath the
case (see page 7-8 fig. 1a/1b).
 Connect power supply to connector 2 located on the rear panel of the unit (see page
7-8).
 Insert power cord into AC outlet, which shall be easily accessible; after few
seconds the balance will automatically switch on.
 Wait 30 minutes from switch on and calibrate the balance using the mass enclosed
in the package, following the instructions (page 10).
 Calibrate the balance again every time it is removed from previous place.
 Check balance calibration periodically.
 We recommend not to drop heavy objects on balance pan, in order to avoid
damages.
 Assistance service must be effected by specialized staff and the spare parts used
must be original.
Therefore, it is necessary to apply to the seller who sold the equipment.
 Keep package in case the balance should be sent back to the factory for service.

INSTALLATION INSTRUCTIONS

3