Electrical Connection Aus, Nz - Miele M 8261 Operating Instructions Manual

Before connecting the appliance,
ensure that it has not been damaged
in any way. Do not use a damaged
appliance.
All electrical work should be carried out
by a suitably qualified and competent
person in strict accordance with
national and local safety regulations.
The appliance is supplied with a mains
cable and moulded plug ready for
connection to an a.c. single phase
220-240 V 50 Hz supply.
The voltage and connected load are
given on the data plate which is located
inside the door to the appliance. Please
ensure that these match the household
mains supply.
Connection should be made via a
suitable switched socket, or via a
suitable isolator, which complies with
national and local safety regulations,
and the on/off switch should be easily
accessible after the appliance has
been installed. If it is installed via an
isolator switch, connection must be
carried out by an electrician.
For extra safety it is advisable to install
a residual current device with a trip
current of 30 mA.
WARNING
THIS APPLIANCE MUST BE
EARTHED
If the connection cable is damaged
it must be replaced by a Miele
approved Service Technician only.

Electrical connection AUS, NZ

53