Installation - Hayward hydrorite uvo3 Owner's Manual

2” residential uv/ozone sanitizing system

Hide thumbs Also See for hydrorite uvo3:

Troubleshooting manual (41 pages)

Troubleshooting manual (55 pages)

Table of Contents

Before starting your installation, you MUST read this manual in its entirety in order to install your unit in a safe manner. Note that a few moments spent becoming

familiar with the HydroRite unit and its installation may save a great deal of time (and expense) later. If you have any questions that are unanswered when you

have completed the reading of this manual, contact your supplier or Hayward.

Overview

NOTE: In-line Chemical feed-

ers and chlorinators should be

plumbed AFTER the HydroRite

system

Filter

Pump

FROM

POOL

Determine a suitable location

Installation of HydroRite system requires mounting the controller and vessel, plumbing the vessel, venturi and flow switch (on the return side of the filter pump),

and finally, connecting the required cables. Remove power to the pool filter pump before starting this installation. Installation must be performed in accordance

with local and NEC code.

The HydroRite vessel must be mounted at least 10 ft. from the pool. The controller must be mounted a minimum of 6 ft. horizontal distance (or more, if local

codes require) from the pool and has a 6 ft. power cord that must be connected to a GFCI protected circuit. Refer to the diagram above for lengths of other cords

and the venturi tube. Note that the vessel and flow switch will be plumbed into the return plumbing after the heater and all other equipment with the exception

of chemical feeders and chlorination systems.