Hayward hydrorite uvo3 Owner's Manual page 7

Controller Connections
Flow Switch and Interlock Cable
Refer to the diagram below. The flow switch and interlock cables both use an RJ-11 connector that plug into the bottom of the HydroRite controller. The con-
nectors are not labeled and either connector can be used.
Bottom of Controller
Insert Flow Switch and
Interlock cables here
(use either connector)
Input Power
HydroRite uses a linecord for input power and must be plugged into a 120V 50/60hz GFCI protected outlet. NOTE: Should the electrical power cord of your
HydroRite unit become frayed or damaged, unplug it from the power receptacle and contact Hayward. USE OF A FRAYED OR DAMAGED POWER CORD COULD
RESULT IN ELECTRICAL SHOCK CAUSING SERIOUS BODILY INJURY, INCLUDING DEATH.
Pool Preparation
Water Preparation
Now that HydroRite has been plumbed and wired, start the pool pump and verify that there are no leaks at the vessel. Before starting operation of HydroRite,
the pool's chemistry should be checked and adjusted to the recommended levels shown below. If opening the pool for the first time of the season, sanitize and
balance the pool BEFORE operating HydroRite.
NOTE: UV light, whether from HydroRite or the sun, will deplete the pool's chlorine over time. It's important to maintain the proper level of Cyanuric Acid (Sta-
bilizer) to prevent this reaction. Use the recommended level of Cyanuric Acid regardless of whether it is indoors or outdoors.
6
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS