Installation Procedure - Toshiba GD-1190 Service Manual

[2] INSTALLATION PROCEDURE

The unpacking and set-up procedure shall be done by a qualified
service technician.
<Before installation>
For improvement of workability, some description in this manual as
well as components and accessories may change without prior notice.
In this case, refer to the service manual.
Turn off the main switch of the copier and then remove the power plug
of the copier from the outlet.
1. Parts included
2. Installation procedure
RADF
(1) Detach the ADF/
Detach the ADF/ RADF from the copier and softly place it on top of the
original table as shown below.
.
GD-1190 INSTALLATION PROCEDURE 2 - 1
(2) Remove the rear cabinet.
1) Unscrew the screw and remove the rear cabinet shielding plate.
(Save the screw.)
2) Unscrew three screws and remove the rear cabinet. (Save the
screws.)
(3) Attach the speaker unit.
Attach the speaker unit using a supplied screw as shown below.
(4) Attach the FAX modem PWB.
1) Attach sponge A and sponge B on the back of FAX PWB.
2) Unscrew the screw holding the ground terminal of the copier.
(Save the screw.)
3) Insert two supplied screws and tighten them loosely as shown
below.