Setting - Mercedes-Benz Comand Operating Instructions Manual

Display settings
40
Your COMAND equipment
These operating instructions describe all
standard and optional equipment available
for your COMAND system at the time of pur-
chase. Country-specific differences are pos-
sible. Please note that your COMAND system
may not be equipped with all the features
described. This also applies to safety-relevant
systems and functions. Therefore, the equip-
ment on your COMAND system may differ
from that in the descriptions and illustrations.
Should you have any questions concerning
equipment and operation, please consult an
authorized Mercedes-Benz Center.
Important safety notes
G WARNING
If you operate mobile communication equip-
ment while driving, you will be distracted from
traffic conditions. You could also lose control
of the vehicle. There is a risk of an accident.
Only operate this equipment when the vehicle
is stationary.
G WARNING
SD memory cards are small parts. They can be
swallowed and cause asphyxiation. This
poses an increased risk of injury or even fatal
injury.
Keep SD memory cards out of the reach of
children. If an SD memory card is swallowed,
seek immediate medical attention.
You must observe the legal requirements for
the country in which you are currently driving
when operating mobile communications
equipment in the vehicle.
Display settings
Setting the brightness
The brightness detected by the display light
sensor affects the setting options for this
function.
Press the Ø button on the COMAND
X
control panel.
or
Press Vehicle in the main function bar.
X
The vehicle menu is displayed.
To select System Settings: slide 6,
X
turn and press the controller.
A menu appears.
To select Display: turn and press the con-
X
troller.
A menu appears.
Select Brightness.
X
A control appears.
To select the desired brightness: turn
X
and press the controller.
Display design
The display features optimized designs for
daytime and night-time operation. You can
set the design by manually selecting day or
night design or opt for an automatic setting.
Press the Ø button on the COMAND
X
control panel.
or
Press Vehicle in the main function bar.
X
The vehicle menu is displayed.