ENGINE BREAk-IN
The first 10 hours of operation should be considered the "Break-in" period
and special attention shall be paid to the following points:
1.
Do not throttle past half throttle during the first 10 hours of operation.
Fluctuate the throttle during this period to break in engine components.
Do not put excessive load on engine by climbing steep hills or having
fast starts.
2.
Warm up engine 3-5 minutes prior to operation so all components are
lubricated sufficiently. Failure to allow engine to warm up could cause
damage to engine.
SWITCHES ON RIGHT HANDLEBAR
Ignition switch
The ignition switch is Located on the right handlebar.
When switch is turned to "
engine is running and "
When switch is turned to "
lever is kicked.
OPERATION
" (off) position, the engine will not start. If
" (off) button is pushed the engine will turn off.
" (on) position, the engine can start when kick
ON button
12
OFF button