Getting Started; First Time Installation - Bauhn HDPVR2400 Instruction Manual

GETTING STARTED

FIRST TIME INSTALLATION

Note: Be sure to have the power cord connected to the mains, and the power point
switch turned ON. (It is recommended that you protect the PVR by connecting to the
power point through a good quality home theatre surge protector board. This will
supply clean filtered power and protect your sensitive equipment from power surges
and electrical interference)
1. After all the connections have been established, switch on your TV.
2. Turn on the PVR by pressing the Power On switch on the front panel.
3. If you are using the receiver for the first time or after a restoration to Factory
Default, a First Time Installation menu will be displayed to guide you through the
scanning of channels.
4. When finished the scanning, all active TV and Radio channels found by the tuner for
your viewing area, will be stored automatically. Reception quality (signal strength)
depends upon many factors such as aerial suitability for digital signals, condition of
the aerial leads from antenna to Wall Socket and from the wall socket to the PVR.
5. If you want to stop the scanning, press the EXIT key to exit. The channels already
found will be stored).
6. Now you are ready to watch digital TV channels and radio broadcasts.
7.
In case you skip the First Time Installation screen, you can press the MENU key to
bring up the main menu again and go to the Installation Screen.
8. A list of all digital channel frequencies can be downloaded from this site:
http://www.acma.gov.au/webwr/_assets/main/lib100059/tv_8.pdf. Current April 2009. To
get an updated list, visit the site again and download the latest version. Digital Channels
are highlighted in blue in the .pdf. Each location has its own particular frequencies, simply
look up your area on the list. eg. Different channels may be available in each location from
a different transmitter. One might be north of you e.g. Broker's Nose, NSW, another south
Knight's Hill, NSW. Your aerial needs to be pointing directly at the correct transmitter to get
the best quality signal.
After Sales Support TEL: 1300 766 659
13