Miele CVA 4062 Operating And Installation Instructions page 58

Frequently asked questions
The coffee/espresso is not hot enough.
Possible fault
– Were the supply lines and cup
pre-heated?
– The temperature is set too low.
– Check if the brew unit is clogged.
No drink is prepared although the beans were grinded and enough water is
in the container.
Possible fault
– The grind control is set to the
finest or the amount of coffee is
set to the maximum.
– The process is timed, the process
might need so long, there is no
time for brewing any more.
The door cannot be closed.
Possible fault
– Check if all containers are
properly inserted.
– The door hinges need to be
adjusted.
The steam heating system is turned off but steam can still dispensed.
Steam can be dispensed as long as the steam heating system is heated. Once it
has cooled, steam can only be dispensed once the steam system has heated.
The coffee dispensing is interrupted.
Possible fault
The water tank is empty.
58
Solution
– The smaller the cup, the more important
it is to pre-heat.
– Check on what temperature range the
coffee type is set.
– Clean the brew unit.
Solution
– Adjust the grind control slide to a
different position, or the amount of
coffee more or less.
Solution
See "Installation Instructions".
Solution
Refill the water tank with fresh cold tap
water.
You will be asked whether you would like
the coffee dispensing to continue after the
water tank has been filled. If you do not
confirm with "OK" within 5 minutes the
coffee preparation will be canceled.