Storage - Hisun HS400 Service Manual

STORAGE

Several months of non-use can cause a
general deterioration of the UTV. This is
especially true in areas of extreme
temperature variations. This deterioration
can be minimized with careful preparation
for storage. A properly stored UTV is much
easier to return to service.
Storage Area Selection
When selecting a storage area, consider
the following:
1. The storage area must be dry. A
heated area is best, but not
necessary. It should be insulated to
minimize extreme temperature
variations.
2. If the building has large window
areas, mask them to keep sunlight
off the UTV.
3. Avoid buildings in industrial areas
where corrosive emissions may be
present. Avoid areas close to
saltwater.
4. Consider the area's risk of fire, theft
or vandalism. Check with an insurer
regarding UTV coverage while in
storage.
.
General
Preparing the UTV for Storage
The amount of preparation a UTV should
undergo before storage depends on the
expected length of non-use, storage area
conditions and personal preference.
Consider the following list the minimum
requirement:
1. Wash the UTV thoroughly. Make
sure all dirt, mud and other debris
are removed.
2. Start the engine and allow it to
reach operating temperature. Drain
the engine oil regardless of the
riding time since the last service. Fill
the engine with the recommended
type of oil.
3. Drain the fuel tank, fuel lines and
carburetor.
4. Remove the spark plug and ground
the ignition system with a grounding
tool as described in this chapter.
Then pour a teaspoon (15-20ml) of
engine oil into the cylinder. Place a
rag over the opening and Start the
engine over to distribute the oil.
Remove the grounding tool and
reinstall the spark plug.
5. When the engine has cooled to
room temperature, drain the cooling
system drain the coolant in the
coolant reserve tank and all tank
lines.
6. Cover the exhaust and intake
opening.
1-36