Hisun HS400 Service Manual page 176

3. Install:
• gasket (1)
• parking brake case (2)
• parking brake case bolts (3)
22Nm (2.2 m · kg,16 ft · lb)
• O-ring (4)
4. Install
• parking brake arm shaft (1)
• parking brake arm (2)
• set bolt (3)
• parking brake arm nut (4)
Note:
Apply lithium-soap-based grease to
the parking brake arm shaft and set
bolt .
Screw in the parking brake arm shaft
counterclockwise completely so that the
punch mark (a) on the parking brake
arm
shaft is between the alignment marks
(b).
CHASSIS
Note:
The hole for the parking brake arm shaft
has multiple threads. If the punch mark
(a) on the parking brake arm shaft is not
between the alignment marks (b) when
the parking brake arm shaft is screwed in
completely, remove the parking brake
arm shaft and screw it in from a different
starting position.
Turn the parking brake arm shaft
approximately 60° clockwise.
Install the parking brake arm to the parking
brake arm shaft so that the punch mark (c)
on the parking brake arm is aligned with the
punch mark (a) on the parking brake arm
shaft.
Turn the parking brake arm until it contacts
the pin (d).
Finger tighten the set bolt.
Tighten the parking brake arm nut.
Install the brake pad (piston side) (1) with the
insulator and pad shim.
Note:
Align the projection a on the piston side
of the brake pad with the groove in the
brake caliper piston.
Install the brake pad holding bolts.
17Nm (1.7 m · kg,12 ft · lb)
5-24