Shock Absorbers - Hisun HS400 Service Manual

ADJUSTING THE FRONT SHOCK
ABSORBERS
Warning:
Always adjust both shock absorbers spring
preload to the same setting. Uneven
adjustment can cause poor handling and
loss of stability.
Adjustment
Turn the spring preload adjuster (1) to
increase or decrease the spring preload.
Standard position: 2
Minimum (Soft) position: 1
Maximum (Hard) position: 5
CHECKING THE TIRES
Warning:
Tire characteristics influence the handling
of the vehicle. If other tire combinations are
used, they can adversely affect your
vehicle's handling characteristics and are
therefore not recommended.
Maintenance and Adjustment
3-25
Recommended tire pressure
Front 70Kpa or 10 psi
Rear 70KPa or 10 psi
Tire pressure below the minimum
specification could cause the tire to
dislodge from the rim under severe
riding conditions.
Use no more than
Front 77Kpa or 12 psi
Rear 77Kpa or 12 psi
when seating the tire beads. Higher
pressure may cause the tire to
burst.
Inflate the tires slowly and carefully.
Fast inflation could cause the tire to
burst.
MAXIMUM LOADING LIMIT
350 lb capacity rear manual dump
bed
1200 lb towing capacity