Basic Operations; Turning On/Standby; Signal Source Selection - Tatung TME24 User Manual

Remark: The picture may be different from the remote control; please refer to the actual product.
Installing battery
Remove the battery cover, and insert two AAA (1.5V) batteries; make sure that the polarity of the battery is consistent with the marks "+/-"
in the battery slot.
Precautions of remote control usage
● Point the remote control to the receiver window. The objects between remote control and the receiver window may disturb the normal
operation.
● Keep the remote control away from strong vibration. In addition, do not set or put the remote control in direct sunshine, which may result
in deformation of the remote control.
● The remote control may be invalid if the receiver window is in direct sunshine or strong light; in this case, please adjust the angle of the
light or the device, or approach the remote control to the receiver window.
● The effective range of the remote control may be affected if the battery voltage is low; in this case, please replace with a new battery; if
the remote control won't be used or battery voltage is too low, please take out the battery to avoid corrosion due to battery liquid leakage.
● Do not mix different types of batteries, or used and new batteries.
● Do not throw the batteries into fire, charge or break up, or charge, short circuit, disassemble, heat or burn the used batteries. Please
follow the environmental protection regulations to disposal of the batteries.

Basic Operations

Turning on/Standby

Insert the power plug into the outlet. P
switch the Monitor set to standby state.
★ Special note
This device adopts energy saving technology:
1. If there is no signal input in power on state, the Monitor set enters standby state automatically after five minutes.
2. When the schedule power off time is reached, the Monitor set enters standby state automatically.

Signal source selection

Press ''SOURCE'' key either on the remote control or on the control panel. The menu of "Input Source" will be displayed on the screen.
ress " " key on the Monitor set, and press
10
" " key to turn on the Monitor , then press the " " key to