Table of Contents
Advertisement
Remote Control
' "
Installing battery
Remove the battery cover, and insert two AAA (1.5V)
batteries;
make sure that the polarity of the battery is
consistent with the marks "+/-" in the battery slot.
Precautions of remote control usage
•
Point the remote control to the receiver window. The objects between remote control and the receiver
window may disturb the normal operation.
•
Keep the remote control away from strong vibration. In
addition,
do not set or put the remote control in
direct sunshine
,
which may result in deformation of the remote control.
•
The remote control may be invalid if the receiver window is in direct sunshine or strong light; in this case
,
please adjust the angle of the light or the device, or approach the remote control to the receiver window.
•
The
eff,
e ctive range of the remote control may be affected if the battery voltage is low; in this case
,
please
replace with a new
battery;
if the remote control won't be used or battery voltage is too low, please take out
the battery to avoid corrosion due to battery liquid leakage.
•
Do not mix different types of
batteries,
or used and new batteries.
•
Do not throw the batteries into fire, charge or break up, or charge, short circuit, disassemble, heat or bum
the used batteries. Please follow the environmental protection regulations to disposal of the batteries.
Basic Operations
Turning on/Standby
Insert the power plug into the outlet. Press"
0"
button on the Monitor set(lf it doesn't have this
button,
you needn't
operate this
step),
and press"
l!J"
key on the remote control or on the control panel to tum on the Monitor set. When
the Monitor set is working, press
"l!J"
key to switch the Monitor set to standby state.
*
Special note
This device adopts energy saving technology:
1. If there is no signal input in power on state, the Monitor set enters standby state automatically after five minutes.
2. When the schedule power off time is reached
,
the Monitor set enters standby state automatically.
Signal source selection
Press "SOURCE" key either on the remote control or on the control panel. The menu of
"Input Source" will be displayed on the screen. Then press
"J;,J~"
key on remote control
or "CH+/CH-" key on the control panel to choose the signal source. Press "OK" key on the
remote control or "MENU" key on the control panel and Monitor will switch the current signal
source to the signal source you choose.
Menu operation description
Press "MENU" key on the remote control or on the control panel
,
then the Monitorwill display the main menu.
1. Press
"~/~"
key on the remote control or "VOL+NOL-" key on
the control panel to select the adjustment sort menu
,
which
includes 4 sorts: PICTURE, SOUND, OSD, Monitor.
2. Press
"~"
key on the remote control or "CH_" key on the control
panel to enter the adjustment sort menu.
3. Press
"Ji./~"
key on the remote control or "CH+/CH-" key on the
control panel to select what is needed to adjust in sort menu
.
7
r - - - - - - - - - - ,
Advertisement
Table of Contents
