Programming A Rolling Code System - Toyota 2016 RAV4 Owner's Manual

● Device with rolling code: If the indicator light flashes rapidly,
your garage door opener motor (or other device) is equipped
with a rolling code. Complete the programming process by
firmly pressing and holding the programmed HomeLink
ton for 2 seconds and then release the button.
● If the garage door or other device does not operate, proceed
to "Programming a rolling code system".
5
Repeat the steps above to program another device for any of the
remaining HomeLink
■

Programming a rolling code system

1
Locate the "Learn" or "Smart"
button on the garage door
opener motor in the garage.
This button can usually be found
where the hanging antenna wire
is attached to the unit. The
name and color of the button
may vary
Refer to the owner's manual
supplied with the garage door
opener motor for details.
2
Press and
"Learn" or "Smart" button.
Perform
onds after performing
RAV4_OM_OM42A41U_(U)
6-4. Using the other interior features
®
buttons.
by manufacturer.
release the
3
within 30 sec-
2
.
525
®
but-
6