Art.2321-2321/P; Power Supplies For Vx2300 - Videx 4333 Kristallo Series User Manual

Art.2321-2321/P

Art.2321
157,5
Fig.1
DESCRIPTION
These two units are specific power supplies for VX2300 digital system. The 2321 can be used for systems with 1 entrance up to 20 users while the
2321/P is for systems with more than 1 entrance and up to 100 users.
CONNECTION TERMINALS AND JUMPERS
Terminal/Jumper Description
0
Mains input
~230V
BUS +
BUS terminals
BUS -
BUS +
BUS terminals (only Art.2321/P)
BUS -
V1
Jumper to adjust the output voltage (only Art.2321/P). V1=Low, V2=Medium, V3=Maximum. Set to maximum (V3) when the
V2
unit is used together with 2301N, otherwise leave in a low or medium position
V3
CONNECTION TO MAINS AND POWER SUPPLY MOUNTING INSTRACTIONS
The system must be installed according to national rules in force, in particular we recommend to:
- Connect the system to the mains through an all-pole circuit breaker which shall have contact separation of at least 3mm in each pole and shall discon-
nect all poles simultaneously;
- The all-pole circuit breaker shall be placed for easy access and the switch shall remain readily operable.
POWER SUPPLY INSTALLATION
- Remove the terminal side covers by unscrewing the retaining screws;
- Fix the power supply to a DIN bar or directly to the wall using two expansion type screws;
- Switch off the mains using the circuit breaker mentioned above and then make the connections as shown on the installation diagrams;
- Check the connections and secure the wires into the terminals;
- Replace the terminal covers and fix them using the relevant screws;
- When all connections are made, restore the mains.
SPECIFICATION
Housing/Mounting 9 Module A Type DIN box (Art.2321) – 15 Module A Type DIN box (Art.2321/P) / DIN Bar or directly to the wall
Push Buttons N/A
Programming N/A
Controls Voltage amplification (3 levels)
Power Supply
230Vac
Working Temperature -10 +50ºC
CUSTOMER SUPPORT INFORMATION
All Countries Customers
VIDEX Electronics S.p.A.
www.videx.it
Tel.+39 0734 631669
Fax +39 0734 632475
The product is CE marked demonstrating its conformity and is for distribution within all
member states of the EU with no restrictions.
This product follows the provisions of the European Directives
89/336/EEC & 92/31/EEC (EMC),
73/23/EEC (LVD) and 93/68/EEC (CE marking).
PrtCode:66550045EN.doc – Pag.18/18
BUS
65
– technical@videx.it
Two Wire Videokit ESVK Series

Power supplies for VX2300

Il prodotto è marchiato CE a dimostrazione della sua conformità e può essere distribui-
to liberamente all'interno dei paesi membri dell'unione europea EU.
Questo prodotto è conforme alle direttive Europee
89/336/EEC & 92/31/EEC (EMC),
73/23/EEC (LVD) e 93/68/EEC (Marcatura CE).
15/02/2013
UK Customers
VIDEX Security LTD
www.videx-security.com
Tech Line 0191 224 3174
Fax 0191 224 1559
Fig.2
Rev.1.0