Checking glass movement
Once the fireplace has been brought
close to its final location, please check
that the counterweight cables run in
the groove of the pulleys [photo 1].
Unlock the counterweights using the
3 mm Allen key [photo 2].
Do not forget to perform this
operation before fitting the fireplace
into masonry !
Make sure the window moves
properly ; then raise it to the full
[photo 3].
Never tilt more than 90°.
Locating the glass protection and smoke outlet
Fitting the upper extension
or the lid
Depending on the option selected,
attach the extension (full opening)
[photo 1] or the cover plate (partial
opening) [photo 2] using the screws
supplied with the stove.
Fitting the smoke outlet
Screws are already in place when you
receive the appliance.
Remove them [photo 3].
Position the seal supplied with the
appliance, it ensures air-tightness
between the smoke outlet and the
hearth body [photo 4].
Stûv 21 - installation [en] - 04-2013
24
SN 132150- ...
1
3
1
3
2
2
4