Fisher & Paykel Titan Aerotech OD302US Service Manual page 61

Service Manual 546596A: 302 Series Titan Oven
Bake element
Location: Under the oven cavity
Removal
1. Follow the general servicing instructions for components in
the back panel area. (refer to Section 7.3)
2. Remove the two largest vent ducting sections.
For Single Ovens and Double Oven Lower Cavity
1. Remove the two screws on the bake element cover.
2. Bend the element cover down to clear the element.
3. Remove the element wires.
4. Remove the element retaining screw.
5. Pull the element out from under oven cavity.
Reassembly
Refit in reverse manner.
Follow the reassembly procedure. (refer to Section 7.5)
For Double Oven Upper Cavity
1. Remove the remaining section of vent ducting.
2. Disconnect the lower vent fan wires.
3. Remove the lower vent fan.
4. Remove the element wires.
5. Remove the two screws retaining the fan cover.
6. Pull the fan cover with the cooling fan attached upward to clear
the locating tabs.
7. Allow the fan cover to drop down to clear the element.
8. Remove the element retaining screw.
9. Pull the element out from under the oven cavity.
Reassembly
Refit in reverse manner.
Note: When reinserting the element use a wide flat blade or similar object to lift the
cavity insulation clear of the replacement element.
Follow the reassembly procedure. (refer to Section 7.5)
Fan cover screws
Fan Cover
Retaining Screws
Figure 7.15b
61
June 2005
Largest
Ducting
Sections
Bake Element
Cover Screws
Figure 7.15a