Bang & Olufsen BEOLINK Handbook page 12

8
Contents
1.5m
Use
Type number
Miscellaneous
MASTER LINK
BeoLink Video
BeoLink Video consists of a control box, a mains cable and a Datalink cable.
Installation also requires a coax cable connected to the HF socket of the
Video system in the main room. The other end of the coax cable connects
to the aerial socket of the link room TV.
3m
BeoLink Video is used in rooms where both sound and picture are to be
reproduced on an older Bang & Olufsen TV without a Master Link socket.
BeoLink Video connects to the link room's TV via the Datalink cable
supplied.
BeoLink Video gives you access to all sources in the main room equipment.
It should be especially emphasized that it is possible to operate and watch
SAT programmes and video tapes, and in such cases it is also possible to
watch and operate decoded programs from TV and SAT receivers in the
main room. You can also access all audio sources reproduced through the
loudspeakers in the Bang & Olufsen link room TV. If you wish to have a
broader stereo perspective and higher volume, active loudspeakers can be
connected to the link room TV.
BeoLink Video connects to the TV via the attached 7-pin Datalink-cable and
to the main room system via a Master Link cable. In addition there is a coax
cable (see page 24).
1161566
In addition to the accessories supplied, the installation also requires a
Master Link cable, a coax cable, plugs, sockets and junction boxes (see also
section on installation types, page 23).