Bang & Olufsen BEOLINK Handbook page 10

6
Contents
1.5m
Use
Type number
Miscellaneous
MASTER LINK
BeoLink Active
BeoLink Active consists of a control box, an IR receiver, a cable to the
IR receiver and a mains cable.
5m
BeoLink Active is used in link rooms together with active loudspeakers.
Any type of Bang & Olufsen active loudspeaker can be connected. If you
connect a BeoLab 8000, you will also need a Y link, as BeoLink Active only
has one Power Link signal, and the signal cannot be looped further into
the BeoLab 8000.
BeoLink Active has a built-in sound control circuit, allowing volume and
sound adjustment to be performed individually in relation to the main
room.
The sound adjustment facilitates individual adjustment of balance, bass,
treble and loudness.
BeoLink Active enables you to listen to the sound from all products in the main
room – both video and audio sources.
BeoLab Active provides the following local control options:
- Timer on/off
- PLAY / ST.BY
- Volume adjustment
1163666 (EU)
1163766 (KOR)
1163866 (USA/CDN)
1163966 (JPN)
1168166 (CHN/HK)
In addition to the accessories supplied, the installation also requires a
Master Link cable and plugs, sockets and junction boxes (see also section on
installation types, page 23).