Bang & Olufsen Beolit 12 Manual

Hide thumbs Also See for Beolit 12:

How do I reset my Beolit 12?

If you experience problems with your Beolit 12, you must first try to

make a hardware reset of Beolit 12 and then a reset of Beolit 12 to

factory settings. This may solve the problem.

Press the On/Off button

switch to standby.

If the flashing red light is caused by overheating, you must allow some

time for your Beolit 12 to cool down, before you press the On/Off button

for 15 seconds.

Connect Beolit 12 to the mains supply or make sure that it is charged.

Press the On/Off button

Within 3 seconds, follow the steps below:



Press and hold the buttons 1, 2 and 3 in the order indicated.



When the On/Off button and the volume buttons begin to flash, let go of

all 3 buttons.

During reset, the On/Off and volume buttons flash. When completed, Beolit

12 switches to standby. Note that after a reset to factory settings, you

must set up Beolit 12 again to connect it to a wireless network.

What is reset (factory reset) ...

for 15 seconds. Beolit 12 is reset and will

to switch on Beolit 12.

Table of Contents

Do you have a question about the Beolit 12 and is the answer not in the manual?

Page 1 How do I reset my Beolit 12? If you experience problems with your Beolit 12, you must first try to make a hardware reset of Beolit 12 and then a reset of Beolit 12 to factory settings. This may solve the problem.
Page 2  All network profiles are deleted  The network name of your Beolit 12 is reset to 'Beolit12_XXXXXXX' ('XXXXXXX' corresponds to the serial number )  The profile name is reset to ‘Profile 1’, ‘Profile 2’ and ‘Profile 3’ ...