Changing Bulb For Front Fog Light - Audi A3 Sportback g-tron Owner's Manual

262 Fuses and bulbs
Changing bulb for front
fog light
Removing fog light
Applies to vehicles: with f ront fog lig hts
To
change the bulb, you must remove the fog
Light. Removing the Light requires o certain
degree of practical skill.
Fig. 287 Detail from front of vehicle, left s ide: Remov-
ing trim
Fig. 288 Detail from front of vehicle, left side:
Fo~
light
.. Switch off the ignition and the lights .
.. Take the hook for removing hub caps and
the screwdriver out of the tool kit
Q page 236 .
.. Insert the hook in the hole @ Q Fig . 287 .
.. Insert the screwdriver through the ring on
the hook in order to pull it .
.. Use the screwdriver to pull off the trim
¢Fig. 287
and remove it from the bumper .
.. Use the cross-head blade of the reversible
screwdriver insert
Q
page 236 to remove the
screws (!)
r::;,
Fig. 288 .
.. Carefully take out the fog light housing.
Changing bulb for front fog light
Fi9. 289 Fog light housing removed
.. Press down the tab (!) and unplug the elec-
trical connector @ ¢ Fig. 289 .
.. Turn the bulb holder anti-clockwise and take
it out .
.. Fit the new bulb .
.. If necessary, use a cloth to remove any fin -
gerprints from the glass part of the bulb.
.. Fit the bulb holder into the bulb housing
and turn it clockwise to tighten. Plug in the
electrical connector again .
.. Check whether the new bulb is working .
.. Re-install the fog light unit. The studs @
¢page 262, Fig. 288 help to locate the unit
in the correct position .
.. Tighten the screws (!) ¢ page 262, Fig. 288
and refit the trim panel.
.. Put the tools and jack back in the luggage
compartment.
(D
Note
To install the fog light, follow the instruc-
tions for removal in reverse order.