Audi A3 Sportback g-tron Owner's Manual page 145

been changed, e.g. due to an accident.
Have it checked by a qualified workshop.
- Only use the reversing camera to assist
you if it is supplying you with a good and
clear picture. The quality of the picture
can be impaired by adverse light, dirt on
the lens or a defect.
- Only use the reversing camera when the
boot lid is completely closed . The orien-
tation lines and blue markings are not
shown when the boot lid is open. Please
make sure that there are no objects
mounted to the rear end of the vehicle
which could block the view of the revers-
ing camera.
- The camera lens en larges and distorts
the field of vision. Objects on the screen
are modified and depicted inaccurately.
- In certain situations, people or objects
on the display may appear closer or fur-
ther away than they really are:
- Objects which are not touching the
ground, such as the bumper of a
parked vehicle, a tow-bar or the rear
end of a truck. In this case, do not use
the orientation lines as a guide.
- When you are reversing from a horizon-
tal surface up a gradient or down a hill.
- When approaching protruding objects.
- When the vehicle has been loaded with
a greater load on the rear.
~~~~~~~~~~
CD
CAUTION
- Please observe the safety warn ings¢(!)
in General notes on page 139.
- The orange orientation lines on the MM I
display show the path of the rea r end of
the vehicle if you were to reverse using
the current steering angle. NB: The front
end of the vehicle swings out further
than the rear. Please make sure you keep
a sufficient distance between the vehicle
and any obstacles to make sure that the
exterior mirror or edge of the vehicle do
not collide with the obstacles.
Parking aids 143
Switching on/off
Applies to vehicles: with parking system plus with revers·
ing camera
Switching on
... Engage reverse gear, or
... Press the P.A switch in the centre console
Q
page 141, Fig. 148. You will hear a brief
acknowledgement tone and the LED in the
switch will light up.
Switching between the reversing camera
and graphic display
... Press the cont rol button for Graphic ®
~ page
144, Fig. 154 to show the graphic
display on the screen.
... Press the control button for Rear view to
d isplay the picture from the reversing cam-
era .
Switching off
... Drive forwards faster than 10 km/h, or
... Press the
P-IA
switch, or
... Switch off the ignition.
i
Note
The graphic on the left of the displ.ay helps
identify the critical area of the vehicle.