Audi A3 Sportback g-tron Owner's Manual page 261

Installing bulb for side lights
Applies to vehicles: with halogen headlights
Fig. 277 Bulb housing: Inserting the bulb holder
.. If necessary, use a doth to remove any fin-
gerprints from the glass part of the bulb.
.. Refit the bulb in the headlight housing
c:)
Fig.
2 77
c:)
&.
in General notes on
page 253.
.. Press the connector carefully into the bulb
housing until the bulb is securely seated
<:) Fig. 277.
.. Replace the cover.
.. Check whether the new bulb is working.
CD
CAUTION
Make sure that the cover is correctly seat-
ed to ensure that water cannot enter the
headlight housing and to prevent the
headlight from malfunctioning.
Removing bulbs for turn signals
Applies to vehicles: with halogen headlights
Fi g. 278 Engine compartment: Removing cover
Fuses and bulbs 259
Fig. 279 Bulb holder for turn signal
For illustration purposes,
c:)
Fig. 2 79
shows
the inside of the unit with the headlight re-
moved .
.. Switch off the lights and the ignition.
... Please refer to
Q
&.
in General notes on
page 253 .
.. Open the bonnet.
... Pull off the cover
c:)
Fig. 2 78 .
.. Pull the bulb connector out in the direction
of the arrow Q Fig. 279.
.. Pull the defective bulb out of the connector
and replace the bulb .
Installing bulb for turn signal
Applies to vehicles. with halogen headlights
Fig. 280 Bulb housing: Inserting the bulb holder
... If necessary, use a cloth to remove any fin-
gerprints from the glass part of the bulb .
.. Refit the bulb in the headlight housing
Q
Fig. 280
QA
in Ceneral notes on
page 253.
Turn the bulb connector slightly
to the left and right until it engages in the
holder .
.. Press the connector carefully into the bulb
housing until the bulb is securely seated .
.. Replace the cover .
.. Check whether the new bulb is working .
~