Audi A3 Sportback g-tron Owner's Manual page 121

Setting the speed and activating the
cru ise control
... To set the current speed as the cruising
speed, press the
lsETI
button
c)
Fig. 130.
The speed setting is indicated by the LEDs
@ in the speedometer and is also shown
briefly in the system status indicator @
c) Fig. 131 .
.,. Vehicles with automatic gearbox: To activate
the cruise control when the vehicle is sta-
tionary, the Audi hold assist* function must
have been activated or you must press the
brake pedal.
Switching off the adaptive cruise control
... Push the lever away from you to position @
until it engages. The message ACC: off will
appear.
The LEDs indicating the stored speed in the
speedometer dial will go out.
@ Warning and indicator lamps
· -The adaptive cruise control is switched
on. No vehicle has been detected in front. A
constant cru ising s peed is being maintained.
• -A vehicle in front has been detected. The
adaptive cru ise cont rol regulates the speed to
maintain a constant distance to the vehicle in
front, and brakes and accelerates the vehicle
automatically.
all -
Automatic gearbox: The adaptive cruise
control is switched on. A vehicle in front has
been detected. Y our vehicle is stationary and
will not be set in motion again automatically.
· - The adaptive cruise control alone is not
able to brake the vehicle sufficiently to main-
tain a safe distance to the vehicle in front. You
must intervene c) page 123, Driver interven-
tion prompt.
© Graphical display in instrument cluster
If the adaptive cruise control ls not shown on
the Instrument cluster display, you can call up
the display using the controls on the multi-
function steering wheel
c)
page 29.
Audi adaptive cruise control 119
The graphical display shows you when a vehi-
cle in front is detected and indicates how far
away you are from that vehicle:
No vehicle - No vehicle has been detected in
front.
Vehicle In white · A vehicle has been detected
in front.
Vehicle
in
red - Driver intervention prompt
c) page 123.
The two a rrows on the scale © indicate the
distance to the vehicle in front. If there is no
vehicle in front, no arrows will be shown. If a
vehicle is detected in front, the arrows
will
be
on the scale .
The green area of the scale represents the dis-
tance setting (for information on how to
change the distance setting, refer to
c)
page 122). When the actual distance is
shorter (or is likely to become shorter) than
the distance selected, the arrows move into
the red area of the scale.
.&.
WARNING
Vehicles with automatic gearbox: If you
press the
ISETI
button at a speed of less
than 30 km/h, the vehicle will automati-
cally accelerate up to the minimum speed
setting of 30 km/h.
-
l
Note
- The speed setting is cleared for safety
reasons when you switch off the ignition
or the adaptive cruise control system.
- When the adaptive cruise control is acti-
vated, you cannot switch on the ESC
sport mode.