Installing Captivator Pro/Tv; Before You Start - VideoLogic CaptivatorPro User Manual

Run the supplied Setup program from Windows before fitting
Captivator Pro/TV inside your computer. See page 12 for
detailed information on the Setup program.

Before you start

Check the ReadMe file on the Setup disk before you install
Captivator Pro/TV. This file contains information that was not
available when this guide was printed.
Make a note of the serial number of Captivator Pro/TV on page
58.
Base address settings
Captivator Pro/TV is supplied with a base address jumper setting
of 350 hex that should suit most installations. If the jumper
position needs to be changed, the Setup program shows you how
to make the alterations before you install the card. Do not
reposition the jumper unless the Setup program recommends an
alternative setting. For further information on the jumper
settings, see Base address settings on page 55.
Installing VM-Channel enabled graphics cards with
Captivator Pro/TV
If you are installing a VM-Channel graphics card, such as
928Movie or PCI Movie, as well as Captivator Pro/TV, install the
graphics card with its software before installing the
Captivator Pro/TV software and card.
Installing multiple VM-Channel enabled cards
If you are installing more than one Captivator Pro/TV, or
Captivator Pro/TV with another VM-Channel enabled add-in
card, read the ReadMe on the Setup disk.

Installing Captivator Pro/TV

Installing Captivator Pro/TV Contents 11