Advertisement
GrafixStar 450 User Guide
Installing GrafixStar 450
Installing the GrafixStar 450 hardware
Note: If you are installing GrafixStar 450 for Windows 3.1, make sure you have configured
Windows to run with a standard VGA display before installation. You can do this by using the
Windows Setup from the Main program group, clicking Change Systems settings from the
Options menu and clicking VGA from the display list box. You can also run the Windows Setup
program from DOS. See the Windows User's Guide for details on how to do this.
Warning: Always switch off your computer before removing the cover and observe the
warnings specified in the manufacturer's documentation. All cables connected to the card
should be properly shielded and comply with radio frequency interference standards.
The diagram below shows the connectors on the card.
monitor
connector
PCI bus connector
- 3 -
Advertisement
