Error Messages - VideoLogic CaptivatorPro User Manual

iv. If the error message appears when you capture large video
Problem 'Capture driver is not installed' or 'Cannot open capture driver.
Driver is not installed.' error message when starting a Video for
Windows application.
Condition The base address setting does not match the jumper setting on
the card.
Solution Change the jumper setting on the card to correspond to the base
address shown in the Setup dialog box.
Condition The Captivator Pro/TV software is incorrectly installed.
Solution Remove the Captivator Pro/TV software—see the ReadMe file
on the Captivator Pro/TV Setup disk. Rerun the Setup program to
reinstall the Captivator Pro/TV software.

Error messages

"Error: 0x012a, VDI_ERR_NO_BOARD_EXISTS"
i. You have installed the software and scanned your system, but
ii. The base address setting does not match the jumper setting on
iii. There is a base address conflict with another card. Scan your
iv. Software is configured incorrectly. Run Setup again and
"Error: 0x0425, VLPPAPI Error: MW_DMSD_DLL_LOAD_ERROR"
Use a text editor such as Notepad to check that the following
section and line are included in your SYSTEM.INI file in the
WINDOWS directory:
images using Microsoft VidCap, reduce the size of the video
image using the Video Format dialog box.
the Captivator Pro/TV card is not yet installed. Install the
Captivator Pro/TV card.
the card. Change the jumper setting on the card to correspond
to the base address shown in the Setup dialog box.
system for a free base address.
reinstall the software. You do not need to remove Captivator
Pro/TV from your PC.
Troubleshooting Contents 47