Warning Messages - Sony PWS-4400 Operation Manual

1) Indication
Code
D4xx01 AV READ ERROR1, etc.
D5xx01 SLOT Mx INTERFACE ERROR1, etc.
D6xx01 SLOT Mx UNMOUNT ERROR1, etc.
D7xx01 SLOT Mx MOUNT ERROR1, etc.
D80101 SLOT Mx FILE SYSTEM ERROR
E101pp PORT x COND3 BAD, STOP REC
E106pp PORT x FS STUFFED, STOP REC
E108pp PORT x WRITE FAIL, STOP REC
E10901 SLOT Mx CANNOT REC
E43100 INTERNAL MEMORY LACK
E43200 INTERNAL MEMORY WRONG POSITION
1) The portion in lower case letters in the above codes is one of the following
numbers.
pp: Number identifying the corresponding port.
81: Port A
82: Port B
83: Port C
84: Port D

Warning Messages

When one of the problems described below is detected by
the unit, a warning mark appears on the status bar of the
web menu. Operation can continue even when the warning
mark appears. When multiple errors occur simultaneously,
the number of errors is indicated to the right of the warning
mark.
1)
Code Indication
010100 NO EXTERNAL REFERENCE
(NO EXT REF)
020100 LOST LOCK
0601pp PORT x SDI INPUT PHASE NG
(P-x PHASE)
44
Troubleshooting
2)
Description
An error occurred while reading from memory. For details,
refer to the Maintenance Manual.
Cannot use memory because cannot communicate with the
memory inserted in the unit. If this error persists after
turning the unit on again, the unit or memory may be faulty.
An error occurred when attempting to unmount memory.
The memory may not be usable. If error D7xx01 occurs
every time the power is turned on, the data must be
salvaged.
An error occurred when detecting the memory.
If error D7xx01 occurs every time the power is turned on,
the data must be salvaged.
An error was detected with the file system in memory.
If the same error occurs every time the power is turned on,
the memory must be formatted. Follow the on-screen
instructions to format memory.
Recording was aborted because all the swap space to
replace bad memory cells has been consumed in the
memory in use.
Recording was aborted because file system control limits
have been reached in the memory in use. Format the
memory to use it for recording.
Recording was aborted to protect existing data because an
attempt was made to overwrite data in the memory in use.
Format the memory to use it for recording.
An abnormality was detected in an unrecorded area in
memory. This memory cannot be used for recording.
Format the memory to use it for recording.
Some or all of the internal memory boards are not installed.
An internal memory board was inserted in the wrong
position.
xx: Number identifying the error location. For details, refer to the
Maintenance Manual.
zz: Number identifying the error type. For details, refer to the Maintenance
Manual.
After a warning message appears, resolve the cause of the
warning based on the message.
For details on resolving the causes of warning messages,
refer to the Maintenance Manual.
Description
No reference signal is input to the selected REF. INPUT
port. The unit is using the internal reference signal.
Synchronization was lost during playback, recording, or
editing.
The input signals to the HD SDI 1 to 4 connectors on the
indicated port are out of phase.