Table of Contents
Advertisement
Note
The salvage process cannot be stopped once it is
started. Allow plenty of time for the salvage process to
complete.
2
Select [FS Salvage] on the Storage screen of the web
menu.
The salvage process begins and a "Please wait."
message appears.
The message window closes automatically when the
process ends.
Error Messages
If the unit ceases to operate correctly due to malfunction or
an internal system error, the SYSTEM indicator on the
front panel starts flashing yellow or red, and an error
message appears on the web menu screen.
Indication
1)
Code
14xx00
PS FAN1 TROUBLE, etc.
14xxpp
260100
POWER SUPPLY UNIT TROUBLE
960100
CALENDAR CLOCK ERROR
B3xx00
SY CPLD2 INITIAL ERROR, etc.
B3xxpp
B80300
SYS1-NW NO COMMUNICATION ERROR
B9zz00
CP-SYS1 NO COMMUNICATION ERROR, etc.
D101pp
PORT x DIO DMA1 ERROR, etc.
D103pp
PORT x ENC PROC ERROR
D203pp
PORT x DEC PROC ERROR
D3xx01
AV WRITE ERROR1, etc.
When files cannot be restored using
salvage
If files cannot be restored even by performing a salvage,
the internal memory cannot be used in this condition.
Formatting memory will enable you to use it again.
1
If memory for which recording did not end normally is
detected, a warning message appears on the web menu
screen and a confirmation message appears prompting
you to salvage or format memory.
2
Select [FS Format] on the Storage screen of the web
menu.
The format process begins and a "Please wait."
message appears.
The message window closes automatically when the
process ends.
Note
If [Rec Inhi] is set to "On" on the [Setup] tab of the
System screen of the web menu, change the setting to
"Off."
After an error message appears, resolve the cause of the
error based on the error message and then turn the unit
back on. If the error message appears again when the unit
is turned on, contact your Sony representative.
Description
A malfunction of cooling fan motor was detected. For
details, refer to the Maintenance Manual.
A power failure was detected.
An internal calendar clock error was detected.
An error was detected at the device initialization stage. For
details, refer to the Maintenance Manual.
An error occurred in communications with the CPU (SYS1)
on the SY-422 board and the CPU (NW) on the CPU-453
board.
The CP CPU detected a communications error between
CPUs (SYS1, CP). For details, refer to the Maintenance
Manual.
An error occurred in the input/output board data
processing.
Recording or playback may not have been performed
successfully.
An error occurred during encoding. For details, refer to the
Maintenance Manual.
An error occurred during decoding. For details, refer to the
Maintenance Manual.
An error occurred while writing to memory. For details, refer
to the Maintenance Manual.
43
Troubleshooting
Advertisement
Table of Contents
