Table of Contents
Advertisement
f TIME CODE OUT connector
When the time code generator is synchronized to the
external time code signal input on the TIME CODE IN
connector, the external time code is output according to the
[TC Out Select] setting on the Port screen of the web
menu.
g AUDIO (AES/EBU) connector
Inputs the audio signals in AES/EBU format for channels
1 to 8.
For output ports
a HD SDI IN/OUT 1 to 4 connectors
Outputs HD SDI signals (up to four cables).
When [Output Port SDI-1,2,3,4] is set to [Off] on the
[Setup] tab of the [System] screen in the web menu, no
signal is output.
b HD SDI IN/OUT 5 to 8 connectors
Outputs the same signals as connectors HD SDI IN/OUT 1
to 4 (up to four cables).
c HD SDI IN/OUT 9 connector
Outputs an HD SDI signal with superimposed text
information for a monitor. To superimpose text
B Remote input/output section
a REMOTE 1 to 4 (9-pin) connectors
Connects to an external device used to control the unit
using a 9-pin remote control cable.
SONY VTR/Disk protocol, VDCP, and Odetics control
protocols are supported.
b AUX connector
Currently cannot be used.
c REF. INPUT connector and 75 Ω termination
switch
Inputs the reference video signal of the selected field
frequency. Input an HD tri-level SYNC signal or SD black
burst signal.
8
Connector Panel
information, set [Character On/Off] to "On" on the Port
screen of the web menu.
The output signal format can be set to Interlace,
Progressive, or PsF in [Port Configuration] of the [Port]
screen of the web menu. When the playback file format is
a 4K signal, the outputs is down-converted to an HD
signal.
d HD SDI IN/OUT 10 connector
For ports A to C, outputs the same signals as connector HD
SDI IN/OUT 9.
For port D, this outputs one of the following video signals
according to the web menu settings. To output the same
signal as the HD SDI IN/OUT 9 connector, set [Board D
SDI-10 Output] to [Off] on the [Setup] tab of the [System]
screen in the web menu.
• Port A to D signals are output in multi-monitor format
• Same signal output as the HD SDI IN/OUT 9 connector
e TIME CODE IN connector
Not used.
f TIME CODE OUT connector
Outputs the playback time code.
g AUDIO (AES/EBU) connector
Outputs the audio signals in AES/EBU format for channels
1 to 8.
A bridge connection is also supported. Set the 75 Ω
termination switch to OFF if using a bridge connection, or
set it to ON if not using a bridge connection.
d GPIO (25-pin) connector
Parallel I/O connector.
For details, refer to the Maintenance Manual or Interface
Manual.
e NETWORK 1/2 connectors
Connects to a network cable for monitoring the unit by
SNMP, configuring or checking the unit via HTTP,
transferring files via FTP, etc.
Advertisement
Table of Contents
