Alarm Messages - Sony PMW-EX30 Operating Instructions Manual

External devices
Symptoms
The device
connected via
i.LINK interface
does not react as
expected; for
example, no picture
appears on its
screen.

Alarm messages

When operating this unit, the unit may
sometimes output alarm messages such as
the one shown below to the monitor screen.
Alarm messages
Media Near Full
Media Full
Voltage Low
Insufficient Voltage
Cause
It sometimes takes
time for the
connected device to
recognize the
operation.
The input format
(HDV or DVCAM)
set on the
connected device
does not match with
the output format
set on this unit.
The video format is
not set to SP1080/
60i on this unit.
A clip recorded in
the video format
other than SP1080/
60i and SP1080/
24P is played back.
Cause and measures
Free space on the SxS memory card has become
insufficient. Replace it with another at the earliest
opportunity.
No space is left on the SxS memory card. Recording,
clip copying and clip division cannot be performed.
Replace it with another.
The DC IN voltage has become low (stage 1). Check
the power supply.
The DC IN voltage is too low (stage 2). Recording
cannot be performed. Connect other power source.
Remedy
Wait for about 15 seconds. If the
connected device still does not react, do
the following:
• Check the i.LINK cable, for example, by
replugging it.
• Turn the power off, and connect the
cable again.
• Change the i.LINK cable.
Set the connected device to the same
video format as that on this unit. (see page
32).
Set the video format on this unit to
SP1080/60i (see page 32).
Play back a clip recorded in SP1080/60i-
or SP1080/24P-format.
Troubleshooting 101