Table of Contents
Advertisement
area.
2.
Connect one end of an Ether cable to the AG-3621 AP and connect the other end to the
Ethernet LAN port located on your PC.
3.
Turn on your computer, connect the power adapter to the AG-3621 and verify the
following:
The PWR power light goes on.
The LAN light of the wireless access point is lit when connected to a powered on computer.
Configuring the TCP/IP Settings of Your PC
Make sure the TCP/IP protocol has been installed in your PC. Please take the following steps
to set a static IP address in Windows XP/2000.
1.
Go to Start Click control Panel Double-click Network Connections Right-click Local
Area Connection Click Properties
2.
Highlight Internet Protocol (TCP/IP) and click Properties.
Figure 5 AG-3621 Wireless network Connection properties
3.
Select Use the following IP address in the Internet Protocol (TCP/IP) Properties window.
Set your IP address and subnet mask. Configure a static IP address of 192.168.1.x (x
cannot be 1) and 255.255.255.0 for the Subnet Mask. Then click OK button.
8
Advertisement
Table of Contents
