Table of Contents
Advertisement
LAN(100)
Off
On
LAN(LINK/ACT) Blinking Indicates that Data processing(Frequency depends on traffic)
WLAN
Off
On
Blinking Indicates the device is linking or active data through wireless
Table 1 AG-3621 LEDs Information
Installing AG-3621 Access Point
Before installing, you should make sure that Ethernet network is perfectly working. You will be
connecting the AG-3621 to the Ethernet network so that computers with 10/100 Fast Ethernet
adapters will communicate computers on the Ethernet.
Set Up the AG-3621 Access Point Tip:
1.
Before mounting the AG-3621 in a high location, first set up and test the AG-3621 to
verify wired network connectivity.
2.
Prepare a computer with an Ethernet adapter. If this computer is already part of your
network, record its TCP/IP configuration settings.
3.
Configure the computer with a static IP address of 192.168.1.x (x cannot be 1)and
255.255.255.0 for the Subnet Mask.
Please follow the steps below to complete installing of your AG-3621.
Hardware Installation
1.
Combine the AG-3621 antennas into the antenna connector.
Note
Make sure that you connect tightly the External dipole antenna on the
antenna
connector of your AG-3621 AP. A loosen antenna will reduce the
radiant energy or even lose it. In order to improve the RF signal
radiation of your antenna, proper antenna placement is necessary. Try
to place the antenna as high as possible to increase the coverage
LED is blinking.After firmware is upgraded or reset to factory
default, the Access Point will reboot automatically.
10 Mbps Ethernet link is detected but no activity.
100Mbps Fast Ethernet link is detected but no activity.
Indicates no wireless links
Wireless LAN is in service but no activity.
links.
7
Advertisement
Table of Contents
